![]() Including the rudder shaft, the motor shaftand all seals and rubber gommets.Ģ) Some of myrubber grommets are also loose. ![]() Some things I am going to try to fixpotential leak areas:ġ) I am lining all potential seal type leak areaswith Vaseline. ![]() In my opinion, these are the areas where water can be coming in: Hopefully this will seal the leak and also re-enforce the tip of the board. I am going to seal this and cover the front tip with some epoxy or Fiberglassresin. I found the water in the hull is coming from a small leak at the front tip of the board along the line where the two halfs of the board have been glued together. I had a small amount of water inmy motor compartment and a larger amount in the hull. Is your water located in your motor compartment or in the hull? Ah, I too have just performed my second "Surf" test and found some leaking.
0 Comments
Leave a Reply. |